wenn ich auf full-duplex schalten will bekomm ich immer die Meldung das dieses nicht unterstützt wird, was ist denn standartmäßig eingestellt??? Fehler scheint es nicht zu geben hier die Ausgabe eines der Interfaces.
Serial2/0 is up, line protocol is up
Hardware is M4T
Description: Serial zu Ohio
Internet address is 192.168.0.1/30
MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input 00:00:07, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
107 packets input, 6172 bytes, 0 no buffer
Received 83 broadcasts, 0 runts, 1 giants, 0 throttles
10 input errors, 9 CRC, 0 frame, 0 overrun, 0 ignored, 1 abort
105 packets output, 12267 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
4 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up
Zu den Routen, der Netzaufbau sieht wie folgt aus
192.168.0.0/30 Serielle Verbindung von Router Berlin zu Router Ohio
192.168.0.4/30 Serielle zwischen Berlin und Tokio
192.168.0.12/30 Serielle zwischen Ohio und Tokio
192.168.1.0/24 Ethernet an Berlin
zwischen Berlin und Ohio sowie von Ohio nach Tokio habe ich jeweils 2 zwei MBit Modem mangels DCE Kabel Bandwidth wurde auf den entsprechenden Schnittstellen aber auch auf 2048 abgesenkt.
Hier die Routen:
Berlin
Gateway of last resort is 192.168.0.6 to network 0.0.0.0
192.168.0.0/30 is subnetted, 3 subnets
S 192.168.0.12 [1/0] via 192.168.0.2
C 192.168.0.0 is directly connected, Serial2/0
C 192.168.0.4 is directly connected, Serial2/1
C 192.168.1.0/24 is directly connected, Ethernet0/0
S* 0.0.0.0/0 [1/0] via 192.168.0.6
Ohio
Gateway of last resort is 192.168.0.1 to network 0.0.0.0
192.168.0.0/30 is subnetted, 3 subnets
C 192.168.0.12 is directly connected, Serial1/0
C 192.168.0.0 is directly connected, Serial1/1
S 192.168.0.4 [1/0] via 192.168.0.14
S 192.168.1.0/24 [1/0] via 192.168.0.1
S* 0.0.0.0/0 [1/0] via 192.168.0.1
Tokio
Gateway of last resort is 192.168.0.13 to network 0.0.0.0
192.168.0.0/30 is subnetted, 3 subnets
C 192.168.0.12 is directly connected, Serial2/1
S 192.168.0.0 [1/0] via 192.168.0.13
C 192.168.0.4 is directly connected, Serial2/0
S 192.168.1.0/24 [1/0] via 192.168.0.13
S* 0.0.0.0/0 [1/0] via 192.168.0.13
Besten Dank für eure Mühe...