Make sure that you change the configuration register value back to 0x2102.
Complete these steps at the config prompt to change and verify the configuration register value.
c-4006-SUPIII(config)#config-register 0x2102
c-4006-SUPIII(config)# ^Z
c-4006-SUPIII# 00:19:01: %SYS-5-CONFIG_I: Configured from console by console
c-4006-SUPIII#write memory
Habe ich ausgeführt danach hat er nicht mehr automatisch gebootet, dies habe ich dann mit confreg und den Parametern gemacht.
rommon 3 >confreg
Configuration Summary : => ignore system config info => console baud: 9600 => autoboot from: commands specified in 'BOOT' environment variable
do you wish to change the configuration? y/n [n]: y enable "diagnostic mode"? y/n [n]: n enable "use net in IP bcast address"? y/n [n]: n enable "load rom after netboot fails"? y/n [n]: n enable "use all zero broadcast"? y/n [n]: n enable "break/abort has effect"? y/n [n]: n disable "ignore system config info"? y/n [n]: n
change console baud rate? y/n [n]: n
change the boot characteristics? y/n [n]: y
enter to boot:
0 = disable autoboot 1 = the first file from internal flash device 2 = commands specified in 'BOOT' environment variable [2]: 1
Danke, jetzt funktioniert es wieder!
Muss man beim Passwort zurücksetzen immer das Config-register 0x2102 ausführen?
