Hi alle,
Ja ich weiss... Ich bins schon wieder :)
Also meine heutige frage ist, wie ich meinen 2. Router anpingen kann?
Der 1. Router ist mit einem DB9 auf Rj45 (Com1 auf Console) am PC angeschlossen.
Der 2. Router ist am Serial1 Port zum Serial1 Port auf dem 1. Router verbunden.
Wenn ich jezt den Befehl "Show dcp neighbors" eingebe bekomme ich nur eine Maske aber keine Router angezeigt. Der Ping selber von cdp ist auf 30 sec. gesetzt
Was an der Sache komisch ist, ist dass ich die Meldung Serial1 Port is UP, Protocol is down bekomme.
Laut CCNA Buch bedeutet das dass die Kabel angeschlossen sind aber das Protokl nicht stimmt.
Habe aber keinen befehl gefunden wo man das Protokoll aendern kann. Weiss einer nen Befehl dafuer?
Router1:
Setup/System summaries:
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes/no]: y
First, would you like to see the current interface summary? [yes]: y
Interface IP-Address OK? Method Status Protocol
BRI0 unassigned YES unset administratively down down
BRI0:1 unassigned YES unset administratively down down
BRI0:2 unassigned YES unset administratively down down
Serial0 unassigned YES unset administratively down down
Serial1 192.160.5.4 YES NVRAM up down
TokenRing0 unassigned YES unset administratively down down
Configuring global parameters:
Enter host name [Router]:
Router2:
Setup / Summaries:
--- System Configuration Dialog ---
carrier-delay Specify d
Continue with configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for he
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: n
First, would you like to see the current interface summary? [yes]: y
Interface IP-Address OK? Method Status Prot
ocol
BRI0 192.168.5.5 YES NVRAM administratively down down
BRI0:1 unassigned YES unset administratively down down
BRI0:2 unassigned YES unset administratively down down
Serial0 unassigned YES NVRAM administratively down down
Serial1 192.160.5.3 YES NVRAM up down
TokenRing0 unassigned YES NVRAM administratively down down
Configuring global parameters:
Enter host name [Router1]:
Danke