Catalyst6509 Fehlermeldung

[MYOEY 10]

Hallo,

ein Cisco Catalyst 6509 Version 12.2(33)SXH2a ist mit den folgenden Linecard bestückt:

 

-WS-X6704-10GE

-WS-X6748-SFP

-WS-X6748-GE-TX

 

In unregelmässigen Abständen resetet der Switch die beiden ersten Module und spuckt die folgende Fehlmeldung raus:

 

Aug 4 08:45:58: %OIR-SP-3-PWRCYCLE: Card in module 1, is being power-cycled off (Reset - Module Reloaded During Downloa

d)

Aug 4 08:45:58: %C6KPWR-SP-4-DISABLED: power to module in slot 1 set off (Reset - Module Reloaded During Download)

Aug 4 08:46:16: %OIR-SP-3-PWRCYCLE: Card in module 2, is being power-cycled off (Reset - Module Reloaded During Downloa

d)

Aug 4 08:46:15: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set off (Reset - Module Reloaded During Download)

00:00:09: DaughterBoard (Centralized Forwarding Card)

 

 

nach ca. 5-10 sind die Module online!!

 

an Strom liegt es nicht da :

C6509#sho power total

system power total = 5771.64 Watts (137.42 Amps @ 42V)

C6509#sho power available

system power available = 3959.34 Watts (94.27 Amps @ 42V)

 

 

Kann man was damit anfangen??? woran könnte es liegen?

 

 

Gruß

[daking 10]

Hola,

 

besteht das Problem erst seit dem update?

was sagt sh fabric?

was sagt remote command mod x sh ver

was sagt sh diagnostic results mod x (kann sein das die syntax hier nicht passt)

was sagt sh mod?

 

habe da noch was im Hinterkopf mit der LC FW...

mal sehen

 

ciao

[Otaku19 33]

Outputinterpreter :

 

Explanation:This message indicates that the module in the indicated slot was powered

off for the indicated reason. [dec] is the slot number, and [chars] indicates the

power status. In most cases this message appears at switch bootup/reload or at

line card insertion and can be ignored.

Recommended Action: Ensure that this message appeared during normal operation

of the switch. If so, try:

1. Reseat and firmly fix up the module in the chassis.

2. Raise the diagnostic level to complete using the set diagnostic bootup level

command.

3. Reset the line card and se the command show diagnostic module for the test results

on module. This will confirm hardware sanity of the line card.

4. Monitor the switch operation. The recovery procedure depends on the reason indicated

in the message such as not supported, module failed